Order of assembly

• [x] All legs screwed onto structure (3 switches on 1 side)
• [x] Solder if not already done the antenna on antenna board
• [x] Inside panel screwed onto half U
  • [x] waiting on 2/4 of the screws since they will be screwed in with hinge + spacer
• [x] Door with hinge + hinge spacer screwed onto half U
  • [x] need to resin print spacer first
• [x] 80/20 screwed onto half U
  • [x] the holes do not line up so need to drill a new second hole to mount to structure
• [x] Screw boards to bracket independently
• [x] Screw boards to half U
• [x] Screw camera mount assembly together
• [x] Screw camera mount assembly to half U
• [x] Press the two half U’s together a loosely screw brackets make sure the springs are inserted first
  • The structure holes did not match up with holes in deployable and camera mount so we redrilled a second hole, keeping 1 of the existing holes; however this meant that everything got misaligned
  • [x] enlarge cutout in inside panel to account for higher deployable placement (ended up filing down side of deployable
  • [x] cut down side of camera mount to allow space for FC board bracket
• [x] Screw together half U’s
  • [x] check fit in jig
• [x] Loctite all brackets (outside panels yet) (not the feet becuase they use loc nuts!)
• [x] Trace out and attach all wiring
  • 1 wire from FC to each xy solar board (we only wired 2/3)
  • 2 wires from FC to antenna board (top cap debug and rgb)
  • 1 wire between FC and battery
  • 3 wires from foot switches to FC board
  • 2 wires from penguin board to FC board (1 solar and 1 camera)
  • 1 wire from camera (payload) to FC board
• [x] Screw on solar boards
• [x] Screw on antenna board and z-solar board
• [x] Tie the burn wire!